It must be less than 2 times the rated output Wholesale Bevel Helical Gearboxes Manufacturers torque of the reducer. At this time, the overload capacity of the drive motor will continue to increase its output, which may cause the output bearing of the reducer to be affected. This is not only to protect the reducer, but also to prevent the output shaft of the reducer from being twisted.

Except for the broken shaft of the reducer caused by poor assembly concentricity at the output end of the reducer, if the output shaft of the reducer breaks, there are nothing more than the following reasons. First, the rated output torque of the equipped motor is multiplied by the reduction ratio, and the value obtained is in principle smaller than the product The rated output torque of the reducer provided by the sample is similar.

In theory, the maximum working torque required by the user. Second, the overload capacity of the drive motor and the maximum operating torque required in practice must also be considered. In particular, some applications must strictly abide by this criterion. First of all, the wrong selection caused insufficient output of the reducer. The force exceeds 2 times the rated output torque and twists the output shaft of the reducer.

This is mainly because if there is a problem with the installation of the equipment, the output shaft of the reducer and its load are jammed. Some users mistakenly think that as long as the rated output torque of the selected reducer meets the working requirements, it is not true. Secondly, in the process of acceleration and deceleration, if the instantaneous torque applied to the output shaft of the reducer exceeds twice its rated output torque, and this acceleration and deceleration are too frequent, the reducer will eventually be broken

Megosztás a facebookon